LumberJocks

THE GARDEN BENCH #3: The BENCH

  • Advertise with us
Blog entry by yohe posted 05-05-2016 11:49 PM 613 reads 0 times favorited 2 comments Add to Favorites Watch
« Part 2: Garden bench Part 3 of THE GARDEN BENCH series Part 4: Da bench »

This week I put my bench together by putting pocket holes in specific pieces as seen in the picture
Then after that I had to pre drill the hole where my screws
Then I used screws to put it together and put them into my leg which are 4×4

Then to end my work on the bench this week I put a pice of wood between my legs so they would not move in closer to each other as seen in picture
That what I got done this week

where going to go so I did not crack the oak and what I did what used the drill to do that than I used the impact gun to put the screws in as seen in the pucture



2 comments so far

View Tooch's profile

Tooch

1349 posts in 1339 days


#1 posted 05-06-2016 10:01 AM

Yohe this is a great blog entry. lots of pictures that help illustrate the steps you are taking to complete the project. Lets try to figure out the rotation and orientation of each pic.

-- "Well, the world needs ditch-diggers too..." - Judge Smails

View htl's profile

htl

2194 posts in 622 days


#2 posted 05-13-2016 01:43 PM

I think your turning your camera side ways to show more but this makes them show up side ways.
keep you camera level and things should come out better.
Just my $.02
And good start to a fine finish.

-- There's a hundred ways to do anything, alot depends on the tools at hand.

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com