LumberJocks

My first Cutting board

  • Advertise with us
Blog entry by wlojr posted 05-26-2012 12:10 AM 1142 reads 0 times favorited 1 comment Add to Favorites Watch


I have been inspired by many cutting boards, that I have seen on LJ, I used some oak scraps that my father gave me and some walnut scraps I got from a cabinet shops discard bin, I cut the boards with my radial arm saw(no table saw yet) and then glued them up with titebond 3 glue, its the only glue Lowes had that said food safe, after they were good and solid about 2 hours later, I ran them through my planer a few times to get them to a uniform thickness. I then routed them with a roundover bit, and then did a ton of sanding, I finally finished it off with watco butcher block finish, this project was fun and I think one of my nicest small projects to date.



1 comment so far

View Andrew's profile

Andrew

294 posts in 1090 days


#1 posted 05-30-2012 01:44 PM

Nice board – I’d be concerned with wood movement since there are opposing grain direction, but it may not be an issue with something this small.

I do like the look of it though.

-- Andrew - Albany. NY

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase