LumberJocks

Woodworking forum topics tagged with 'spray gun'

  • Advertise with us
All Topics Replies Last post
View tomakazi's profile

What would you make with these?

07-06-2015 04:32 AM by tomakazi in Wood & Lumber

I picked these up today. What would you make out of them? Siz...

2 07-06-2015 04:36 AM
View paxorion's profile

Non-latex paint finishes for HVLP finishing?

06-23-2015 08:42 PM by paxorion in Finishing

Reading a recent thread on HVLP comparisons, I’m curious to hear any th...

13 06-25-2015 10:52 PM
View sanfranciscocedarco's profile

Off-topic content. Click to see the post.

03-07-2015 10:10 PM by sanfranciscocedarco in Coffee Lounge

8 06-23-2015 09:58 PM
View paxorion's profile

Shellac (Zinsser SealCoat) for sealing in odor?

04-24-2014 03:22 AM by paxorion in Finishing

My wife found a chest of drawers on Craigslist that had the retro design elem...

13 06-23-2015 01:37 PM
View KoryK's profile

Craftsmen vs. Artists

10-23-2011 07:16 PM by KoryK in Woodworking Skill Share

I might be wrong, but I think there is a clear difference between craftsmen v...

40 06-22-2015 04:10 AM
View Sanderguy777's profile

What air compressor?

05-26-2015 07:51 PM by Sanderguy777 in Power Tools, Hardware and Accessories

I have a couple nailers ( brad and pin) I want to get a finish too, but I nee...

10 05-29-2015 05:12 AM
View Arlin Eastman's profile

Off-topic content. Click to see the post.

03-22-2015 10:36 PM by Arlin Eastman in Coffee Lounge

8 04-19-2015 08:02 PM
View LyallAndSons's profile

Pro cabinet maker, greenhorn turner question

04-16-2015 09:52 PM by LyallAndSons in Woodturning

This one is out of my wheelhouse so to speak. I’ve made cabinets for a ...

5 04-17-2015 08:38 PM
View jonnybone's profile

Harbor Freight HVLP Turbine Spray Gun Kit #44677

06-02-2011 06:14 PM by jonnybone in Power Tools, Hardware and Accessories

good evening umberocks, I just poichased this unit from The Freight last a...

21 04-07-2015 07:08 PM
View Hartworks's profile

General Finishes Milk Paint sprayed with HVLP Fuji XPC

03-15-2015 06:14 AM by Hartworks in Finishing

So I am doing a large media center for a customer and had some material on ha...

5 03-15-2015 02:06 PM
View sanfranciscocedarco's profile

Ammonia Fuming white oak question

03-07-2015 11:37 PM by sanfranciscocedarco in Finishing

I am going to fume some table tops that I am building. There are 7 of them an...

5 03-08-2015 03:45 AM
View sanfranciscocedarco's profile

What finish to use on outdoor restaurant tables

03-04-2015 03:33 PM by sanfranciscocedarco in Finishing

I am building 7 tables for a restaurant in Northern CA. They are made of whit...

6 03-04-2015 11:07 PM
View Richard's profile

Will this spray gun work with my compressor ?

03-04-2015 12:02 AM by Richard in Finishing

I am looking at getting a spray gun anddidn’t want to start out with to...

5 03-04-2015 05:02 AM
View pjones46's profile

Importance of MSDS sheets....Not Enough Warnings!

01-24-2015 06:51 AM by pjones46 in Finishing

Many(edited) have been under the assumption that with the new waterborne and ...

22 01-25-2015 12:54 PM
View sanfranciscocedarco's profile

water based finish over water based dye question

12-12-2014 08:27 PM by sanfranciscocedarco in Finishing

dyed a piece with a few coats of water based dye then sealed with shellac. I ...

4 12-13-2014 12:36 PM
View scott ernst's profile

Building a dining table in 4 hours

11-16-2014 05:41 PM by scott ernst in Woodworking Skill Share

I recently built a small dining table for my girlfriends new place. I did...

1 11-16-2014 07:03 PM
View GregD's profile

How long can paint sit in a hand-held airless sprayer?

08-19-2014 03:14 PM by GregD in Finishing

I have a hand-held airless sprayer (Graco TrueCoat Pro 2) that I’m tryi...

8 11-05-2014 04:01 PM
View tpcolson's profile

Advice needed on bulk finishing of paneling

10-31-2014 09:03 PM by tpcolson in Finishing

I am faced (due to laziness and a disease called “Serial Home Renovator...

10 11-03-2014 10:36 PM
View ten4cmor's profile

Capspray 10000 experiences and advice needed!

10-14-2014 04:25 AM by ten4cmor in Finishing

Hi Lumberjocks, I recently traded an old fridge for a Capspray 10000 and w...

0 10-14-2014 04:25 AM
View SKlaus's profile

BENJAMIN MOORE ADVANCE VS. SHERWIN WILLIAMS PRO CLASSIC

05-13-2013 10:44 PM by SKlaus in Finishing

Hi everyone! Im trying to understand some products on the market now. I hav...

7 09-15-2014 05:21 AM

1 2 3 4 ... 8 next »
147 topics


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com