LumberJocks

Contractor Saw motor shutdown shutter

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by Scott C. posted 04-23-2015 11:58 PM 523 views 0 times favorited 3 replies Add to Favorites Watch
View Scott C.'s profile

Scott C.

149 posts in 1514 days


04-23-2015 11:58 PM

My Ridgid TS3650 is experiencing some shuttering/jerking when the motor shuts down. It hops a little on start up, but it’s much more noticeable on shut down. When it gets towards the end of shutting down it jumps a bit a makes a pretty audible ca-chunk, if a zero clearance insert is being used you can here the blade make a nice wang sound. If I take the belt off it seems to be fine. It still passes a nickel test though and otherwise runs and cuts fine. Arbor bearing, maybe?

Any advice?

-- measure twice, cut once, swear and start over.


3 replies so far

View knotscott's profile

knotscott

7210 posts in 2838 days


#1 posted 04-24-2015 01:05 AM

Just to eliminate variables, have you tried a different blade? Check that the pulley alignment is good too. You could also consider a different belt before resorting to new bearings.

-- Happiness is like wetting your pants...everyone can see it, but only you can feel the warmth....

View Scott C.'s profile

Scott C.

149 posts in 1514 days


#2 posted 04-24-2015 01:42 AM

Tried different blades, happens with all of them. I should have added, the motor mount is bent, but I have the motor shimmed to make the pulleys coplaner and aligned.

-- measure twice, cut once, swear and start over.

View pjones46's profile

pjones46

986 posts in 2105 days


#3 posted 04-24-2015 03:27 AM

IMO the problem is the motor mount.

-- Respectfully, Paul

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com