LumberJocks

Dowel tenoning jig

  • Advertise with us

« back to Jigs & Fixtures forum

Forum topic by MrRon posted 02-01-2015 06:21 PM 724 views 0 times favorited 2 replies Add to Favorites Watch
View MrRon's profile

MrRon

3926 posts in 2709 days


02-01-2015 06:21 PM

Topic tags/keywords: jig

I needed a way to cut tenons on the end of 5/8” wood dowels, so I came up with this jig. I could have drilled a 5/8” dia. hole instead of the 5/8×5/8 square slot, but the dowels were not perfectly 5/8 dia. I cut the slot a little oversize so the dowel would rotate without binding. I clamped the jig to the router table and used a 1/2” endmill to trim the tenon ends of each dowel down to 3/8” dia. The dimensions are not critical. I used a piece of 2×3 stud and whatever scraps laying around. I had 72 tenons to make and the jig knocked them out in no time.


2 replies so far

View Belg1960's profile

Belg1960

966 posts in 2530 days


#1 posted 02-01-2015 07:04 PM

Ron your jig drawing looks really fuzzy can’t read the words.

-- ***Pat*** Rookie woodworker looking for an education!!!

View MrRon's profile

MrRon

3926 posts in 2709 days


#2 posted 02-01-2015 07:19 PM

I hope this image is better.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com