LumberJocks

Porter Cable PCB660DP Drill press run out

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by Garbanzolasvegas posted 01-20-2015 02:29 PM 1322 views 0 times favorited 3 replies Add to Favorites Watch
View Garbanzolasvegas's profile

Garbanzolasvegas

356 posts in 695 days


01-20-2015 02:29 PM

It would appear my PC DP has some run out which I do not like. I have watched some youtube videos about this and most have replaced either or both the Arbor and/or Chuck but none say where they got them or who made them.

I found a place called Jacobs Chucks but it is all very technical and there is not way to contact them to sake a question.

I don’t want a replacement part(s) such as another part from PC, I want a higher quality After market parts.

I would like to find a site which says what DP these parts are for. All the technical mumbo jumbo is meaningless to me

Any suggestions

-- If you don't Play, you can't win


3 replies so far

View ElChe's profile

ElChe

630 posts in 804 days


#1 posted 01-20-2015 04:45 PM

Is it installed with a morse taper? I assume that it is. I’d make sure the chuck/arbor is seated firmly into the morse taper. I’ve had my Jet drill press chuck come a bit loose and a couple of firm taps with a sacrificial block and a mallet. I first removed it and cleaned both surfaces to make sure there isn’t any grit and then given it a couple of good whacks with a mallet and that has resolved the issue.

As to replacement chucks, you need to find one that fits the morse taper. I’ve never ordered a replacement chuck so no help there. Getting the chuck off the arbor sucks so if you are getting a chuck might as well get an arbor. And if run out is the problem then the arbor may be the culprit?

-- Tom - Measure twice cut once. Then measure again. Curse. Fudge.

View Garbanzolasvegas's profile

Garbanzolasvegas

356 posts in 695 days


#2 posted 01-20-2015 08:52 PM

Its a taper Arbor. I took it out 2 days ago and clean it and the inside part of the quil and the chuck area. Reinstalled gave a few good taps and still run out.

Here is a YOUTUBE vid about the very issue so you can see the parts.

https://www.youtube.com/watch?v=Mr_M1iDWIn0

This guy does the same thing I want to do but doesn’t say where he got the replacement ARBOR…

But if you’ll notice after he gets the new arbor in hes still got some RUN-OUT so I think he needs a new chuck as well.

I alos have seen a lot of folks make a keyless chuck for this DP but again I cant find out what one would fit my DP????

-- If you don't Play, you can't win

View Garbanzolasvegas's profile

Garbanzolasvegas

356 posts in 695 days


#3 posted 01-20-2015 10:22 PM

Closer Found out my arbor is whats called a MT2-JT3 Arbor now at least I can find a chuck that would fit

-- If you don't Play, you can't win

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com