LumberJocks

Underside of a Delta 37-190 jointer

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by jshattoc posted 11-30-2014 05:35 PM 829 views 0 times favorited 1 reply Add to Favorites Watch
View jshattoc's profile

jshattoc

13 posts in 1766 days


11-30-2014 05:35 PM

I was hoping someone could do be a big favor. I had to replace the bearings on my 37-190 jointer. There is a little dust flap with a sponge on it that is attached via the same screws as the cutterhead bearing blocks. So naturally, that came off when I removed the cutterhead. I cant for the life of me figure out how to get that flap back on, even though there’s only 4 different ways it could do. It somehow interfaces with the dust chute that the motor mounts on, but I cant quite figure it out. Would someone be able to take a picture of the underside of this jointer, or describe how that flap is situated? It would really help me out.


1 reply so far

View gabesgarage's profile

gabesgarage

3 posts in 614 days


#1 posted 04-06-2015 04:35 PM

I am having the exact same problem. Were you able to figure it out? Does the foam piece end go up into the machine? It seems to be the only way it fits, but is that too close to the cutter? thanks.

Gabe

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com