LumberJocks

Tips needed on installing/gluing finished inlay.

  • Advertise with us

« back to Finishing forum

Forum topic by Mitchmor posted 11-03-2014 08:58 AM 755 views 0 times favorited 3 replies Add to Favorites Watch
View Mitchmor's profile

Mitchmor

16 posts in 1054 days


11-03-2014 08:58 AM

I’m looking to install a piece of painted/finished wooden inlay into a piece of wood.
(To be specific a painted leaf shaped piece of inlay into the center of a board)

Any tips out there on preventing (or mitigating) the glue squeeze out and sanding duties/clean up that comes with gluing in finished wooden inlay? (in hopes of the finish holding up)

...any tips are Much Appreciated


3 replies so far

View ElChe's profile

ElChe

630 posts in 799 days


#1 posted 11-06-2014 02:13 AM

Maybe liquid hide glue? Then card scrape the inevitable glue out?

-- Tom - Measure twice cut once. Then measure again. Curse. Fudge.

View shipwright's profile

shipwright

7167 posts in 2260 days


#2 posted 11-06-2014 04:26 AM

Use hide glue, hot or liquid and the cleanup is just water. There should be no problem with subsequent finishes on the substrate wood.

-- Paul M ..............If God wanted us to have fiberglass boats he would have given us fibreglass trees. http://thecanadianschooloffrenchmarquetry.com/

View Mitchmor's profile

Mitchmor

16 posts in 1054 days


#3 posted 11-08-2014 06:20 AM

Thank you shipwright and Elche.
I’ll give hide glue a shot, and from looking into it a bit from your suggestions I gather that streaking should not be a problem.
Very good.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com