LumberJocks

tongue & groove hardwood question

  • Advertise with us

« back to Joinery forum

Forum topic by RCharles posted 10-21-2014 10:57 AM 624 views 0 times favorited 1 reply Add to Favorites Watch
View RCharles's profile

RCharles

10 posts in 2817 days


10-21-2014 10:57 AM

Hello,

I have an installed hardwood floor where an edge was cut as part of a renovation. The edge is perpendicular to the long boards; there are fifteen ends of 3” hardwood.

I need to install a trim piece, a matching length of the same oak flooring along this edge. My plan is to route a slot in the ends to fit the tongue side of the trim piece. But the router bits I’ve found have the bearing under the cutter, which makes the cutter two high.

Any solutions?

Thanks
Ray


1 reply so far

View Ger21's profile

Ger21

1047 posts in 2593 days


#1 posted 10-21-2014 11:41 AM

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com