LumberJocks

Walnut floor

  • Advertise with us

« back to Wood & Lumber forum

Forum topic by Peter Bermingham posted 01-26-2014 12:39 PM 569 views 0 times favorited 1 reply Add to Favorites Watch
View Peter Bermingham 's profile

Peter Bermingham

5 posts in 1075 days


01-26-2014 12:39 PM

Just after being offered 60 square meters of water damaged 3/4 walnut floor for free. We had bad weather here in Ireland and the sea made its way into the house haven’t seen it yet but more then likely its cupped. Was thinking to stack it for air drying and then get it kiln dried or what do ye think would be the best way to go about saving it, it will probably never be a floor again but it would be a shame for all that walnut to go to fire wood
Thanks Peter

-- Peter Co Mayo Ireland


1 reply so far

View bold1's profile

bold1

262 posts in 1312 days


#1 posted 01-26-2014 02:08 PM

Hi Peter. Not knowing the moisture content, but assuming it’s high or it wouldn’t have been replaced. I’d get it into a kiln as soon as possible, where I could control the redrying. Drying too fast is going to open up the surface and if it checks too deep you won’t have anything left to work with.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com