LumberJocks

Looking for large roundover Shaper Cutter

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by DangerDoug posted 12-15-2013 03:19 PM 672 views 0 times favorited 4 replies Add to Favorites Watch
View DangerDoug's profile

DangerDoug

62 posts in 1114 days


12-15-2013 03:19 PM

Found this on the inter-web.
http://toolsandmore.us/roman-carbide-dc2214-shaper-cutters.aspx
This would work if it was Left to Right feed, and might just work with it if there are not any other options [ this large at this low price].

Will not be running 100s of feet, really just want the bell shape profile for small projects.

Any thoughts?


4 replies so far

View cabmaker's profile

cabmaker

1507 posts in 2276 days


#1 posted 12-15-2013 03:30 PM

That cutter will run either direction. (Dependent on dia. Capabilities of machine) face up or face down. enjoy!

View DangerDoug's profile

DangerDoug

62 posts in 1114 days


#2 posted 12-15-2013 03:36 PM

Yes thanks….If I run “face-up” I’ll have to put the work down first, then slip cutter over.
Working thru 1-3/4 hole for the reverse bell shape.
That’s a little scary, but maybe ok???

OR should I reverse motor, but again, is that a bad idea?

View cabmaker's profile

cabmaker

1507 posts in 2276 days


#3 posted 12-16-2013 01:58 AM

Can’t say if it is a bad idea or not without knowing what setup you have there. What is your max at table level?

Are you hand feeding?!

View Shawn Masterson's profile

Shawn Masterson

1297 posts in 1415 days


#4 posted 12-17-2013 01:11 AM

You may want to investigate a raised panel cutter.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com