Incra mitre safety question

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by BJODay posted 07-15-2013 12:44 AM 751 views 0 times favorited 1 reply Add to Favorites Watch
View BJODay's profile


527 posts in 2146 days

07-15-2013 12:44 AM

Topic tags/keywords: incra table saw

Hey all,

I purchased an Incra mitre 1000HD. It is very cool and it worked better than expected.

While using it I came across a problem. I was using the work stop and pushed a piece through cutting at a 45 degree angle. To be safe I would have to push through all the way past the riving knife to remove the piece. This would make me push the jig all the way onto the out-feed table. Instead I would push through the cut to mid-blade and turn off the saw. I just felt safer doing this.

My thought was this. Are there saws that use a brake to stop the blade when power is cut? I had a lawn mower that had a blade brake and it could stop the mower blade in less than 2 seconds. Does any one know of a saw with a feature like this?


1 reply so far

View Gary's profile


9386 posts in 3636 days

#1 posted 07-15-2013 12:54 AM

I don’t know about any saw like that but, I use that same gage and on mine, there are two screws that loosen so you can pull that end of the backer board away from the blade.

-- Gary, DeKalb Texas only 4 miles from the mill

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics