Please help! Hand saw veneers

  • Advertise with us

« back to Woodworking Skill Share forum

Forum topic by WestozROG posted 07-10-2013 08:46 AM 490 views 0 times favorited 0 replies Add to Favorites Watch
View WestozROG's profile


1 post in 1745 days

07-10-2013 08:46 AM

Hi everyone,

I’m hoping someone from Australia if not Western Australia might be able to help me with my veneer sawing. I have made a number of attempts to re saw some jarrah veneer up to 100mm thick and I keep destroying blades. I can’t seem to get more than one or two small veneers before the blade is completely blunt? I order my blades from Hughes saw service in Osborne park. I have tried blades around 25 mm 3tpi also I have tried 18 mm 6 tip both have been useless. Am I doing so,e thing wrong or is jarrah just that hard to re saw? I have an old Italian built 18inch bandsaw that has been mostly re builds with all new bearings and wheel rubber. Any suggestions would be greatly appreciated.

Many thanks

0 replies so far

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics