LumberJocks Woodworking Forum banner

Portable Dust collection fixture

Tags
jig tip
2K views 1 reply 2 participants last post by  Grandpa 
#1 · (Edited by Moderator)
I made a portable fixture to hold my shop vac hose while running the router. It consists of a piece of 1/2 inch plywood with a modified shop vac accessory clamped in place. I installed a spacer under the front to support the nozzle. The clamp was too big so I wrapped some duct tape and then some double sided tape to make it thicker.

I attached four 3/4 inch magnets so it will stay put on the cast iron router table. When I am not using it, it rests comfortably on the metal side of the table saw.

Wood Table Thigh Flooring Hardwood


Wood Flooring Floor Wood stain Hardwood


Wood Rectangle Automotive tire Gas Hardwood
 

Attachments

See less See more
6
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top