LumberJocks

sled

  • Advertise with us

« back to Jigs & Fixtures forum

Forum topic by Bsmoot posted 648 days ago 486 views 0 times favorited 3 replies Add to Favorites Watch
View Bsmoot's profile

Bsmoot

64 posts in 1541 days


648 days ago

When I make my cut on my tablesaw sled how high does blade need to be 1/2” 1/4”

-- Bryant north carolina


3 replies so far

View jeff's profile

jeff

634 posts in 2064 days


#1 posted 646 days ago

the post is a few days old and maybe you found the answer but,i would assume just above your material,or have the gullets of the blade just above your material.

-- Jeff,Tucson,Az.

View flskipper's profile

flskipper

24 posts in 2294 days


#2 posted 646 days ago

The same as for cutting without the sled, with the gullets of the saw blade just above the material being cut.

View Charlie's profile

Charlie

1001 posts in 885 days


#3 posted 646 days ago

Interestingly, my Freud blades have instructions to position them so that 1/2 of a TOOTH is above the work. So basically half the gullet is exposed, not the whole gullet. If you do like the instructions say, you get super clean edges top and bottom, too high or too low and you start to see tear out top or bottom depending on if you’re high or low.

Other than that, I’ve always used the “expose the gullet” method.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase