1-Inch Pipe Clamp Fixture

  • Advertise with us

« back to Jigs & Fixtures forum

Forum topic by Joseph Crivelli posted 06-13-2012 12:59 PM 2571 views 0 times favorited 3 replies Add to Favorites Watch
View Joseph Crivelli's profile

Joseph Crivelli

44 posts in 2669 days

06-13-2012 12:59 PM

I have a 1” black pipe (48”) that I’d like to use as a pipe clamp.
I searched the web extensively, but can’t find a suitable clamp fixture.

Does anyone know if a 1” pipe clamp fixture exists?


3 replies so far

View BinghamtonEd's profile


2263 posts in 1787 days

#1 posted 06-13-2012 02:48 PM

Never seen one, but with the cost of pipe for readily available clamp fittings, why not go with something easier to find? A 4’ section of iron pipe goes for around $10 at home stores.

I’d save the 1” pipe, that’d make a good breaker bar.

-- - The mightiest oak in the forest is just a little nut that held its ground.

View Joseph Crivelli's profile

Joseph Crivelli

44 posts in 2669 days

#2 posted 06-13-2012 03:34 PM

I did check the size and it is 1”.

I already have two 3/4” pipe clamps.

Rick, you’re exactly the person I was aiming my question at.

I’ll just have to figure opur something else to use this pipe with.


View crank49's profile


3979 posts in 2389 days

#3 posted 06-13-2012 04:44 PM

Don’t want to beat a dead horse here, but

1” pipe has a 1.315” O.D.

3/4” pipe has a 1.050” O.D.

1/2” pipe has a 0.840” O.D.

-- Michael: Hillary has a long list of accomplishments, though most DAs would refer to them as felonies.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics