LumberJocks

Delta 13" PLANER SNIPE

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by DKO posted 05-22-2012 10:34 PM 961 views 0 times favorited 2 replies Add to Favorites Watch
View DKO's profile

DKO

12 posts in 1830 days


05-22-2012 10:34 PM

Topic tags/keywords: planer

I am getting bad end snipe on the last two three inches of my boards but ONLY ON THE RIGHT HALF OF MY PLANER. If i keep the boards on the left side the cut is perfect. I think there must be an adjustment for this but I don’t know it. Can anyone help?


2 replies so far

View Grandpa's profile

Grandpa

3256 posts in 2140 days


#1 posted 05-23-2012 12:19 AM

most of the time the outfeed table is low. Check it with a strait edge. It would be level or slightly elevated from the bed of the planer. Just raid the cutter head and slip a good straight edge through the plane and adjust the table a little if you think it needs it. the outfeed table is pretty light on those little planers. Good luck.

View cutworm's profile

cutworm

1075 posts in 2258 days


#2 posted 05-23-2012 01:15 AM

A guy at Ridgid told me to use a penny and set the infeed and outfeed tables higher than the center by the thickness of a penny. Haven’t had time to try it.

-- Steve - "Never Give Up"

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com