Craftsman Professional Tablesaw Extension Wing.............

It sounds like you have the 22124 hybrid, which had two 12” solid cast iron wings. Just about any 27” deep wing can be made to fit….some drilling might be required with some, but cast iron drills pretty easily. Steel City/Orion originally made that saw, so a wing from a Steel City model might be a direct fit.

-- Happiness is like wetting your pants...everyone can see it, but only you can feel the warmth....

If you want to add a router table you could always replace with a cast iron table from bench dog, peach tree, etc.

jussi why don’t you sell him your ? where are you locate at ? I might be able to help you out .

I have seen them on eBay, even found an entire top with wings for $100. I would start there.

-- Martin ....always count the number of fingers you have before, and after using the saw.

R U still here Eyedoc?

-- Happiness is like wetting your pants...everyone can see it, but only you can feel the warmth....

I put one on this forum a while back, still have it . If interested send me a message. Have to tell you, shipping might be expensive.

-- Stamper

This was likely a “hit and run” stamper….long gone.

-- Happiness is like wetting your pants...everyone can see it, but only you can feel the warmth....

I am still here and appreciate all of your responses. I ended up buying a benchdog router extension and then drilling and tapping the right extension wing so that I could add the lft extension wing onto it. Worked great and it really gives me a large workspace with substantial mass.

I just recently got a pretty good deal on some Jorgenson parallel clamps. two 36” and two 24”. However, when I got home I noticed some bad reviews on them. Would it be wise to return them and pick up the same sizes in the Bessey clamps?

I would return them and buy some Jet Parallel clamps. I have many styles of clamps including 30 Bessey parallel clamps but the feature Jet has over Bessey is a release trigger. The Besseys are a little annoying because you have to have the tightening screw just right to adjust the clamp. Take a look at Jet’s reviews .

http://toolreviews.woodmagazine.com/hand-tool-reviews/clamps/bar-pipe-clamps/764-jet-parallel-jaw-clamp

-- W James Brokenbourgh Custom furniture maker http://artisticwoodstudio.com/