Veritas Twin Screw Adjustment

Good question as that’s something I’d like to do as well. I’ve been tweaking the last few things on my bench, and that’s something on my need-to-investage list. I assumed (maybe incorrectly?) that you could do it by loosening the set screw on the non-drive screw and re-tightening after they were aligned? If that doesn’t work, the only other way I can think of would be to put thin shims behind one or the other nut-plate so that they jaws close up at the same screw position.

-- Use the fence Luke

Doug has it correct. Loosen the set screw, spin to position and then re-tighten.

Too easy :)

Ryan

-- If you can't set a good example, at least serve as a horrible warning... www.rarewoodcreations.com