My first post so i hope i’m doing this right.Last night i bought this jointer,it is in great condition.it still has the oringial blades in it that are stlll sharp. My problem is the blades are .006 above the out feed table, all 3 blades are set the same height within .001. I can’t get the out feed table to go up or down. So how do you lower the table. or should i lower the blades. Anybudy know where i can get the manural for this. Thanks All skipj
Skipj … there should be some allen head screws on the back of the machine, they call them gib screws and they hold the alignment against the dovetail slide. Lossen theup and you should be bale to move the outfeed table up. I just went through the same deal on my first refurb. Good luck and welcome to the gang.