LumberJocks

Table Saw

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by Warren posted 02-05-2012 02:06 PM 700 views 0 times favorited 2 replies Add to Favorites Watch
View Warren's profile

Warren

81 posts in 1799 days


02-05-2012 02:06 PM

Topic tags/keywords: tablesaw tip

Yesterday while cutting some wood out in the shop I realized my ends where not square. I was cutting light wieght wood so I know it wasnt the wood being to hard, with that said I slowed my infeed to the blade down to a crawl. But that wasnt my problem my problem was the saw blades I was using were cheap blades and where warped, of course I have had these blades for a few years, goes to show you cheap blades means cheap progress, better to pay a few bucks for a good blade as it is to pay a few hundred to replace expencive wood.

-- Warren, Cambridge,OH.


2 replies so far

View Chipy's profile

Chipy

374 posts in 2057 days


#1 posted 02-05-2012 02:13 PM

Sounds like you could use a Froest/Frued/Amanna blade and a cut off sled.

View knotscott's profile

knotscott

7212 posts in 2839 days


#2 posted 02-05-2012 02:50 PM

Well said….most of us go thru a similar epiphany before we’ll put up the money for good blades.

-- Happiness is like wetting your pants...everyone can see it, but only you can feel the warmth....

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com