WTB Rigid table saw fence model#2424 1

  • Advertise with us

« back to Woodworking Trade & Swap forum

Forum topic by Redcloud posted 12-31-2011 10:08 PM 2084 views 0 times favorited 4 replies Add to Favorites Watch
View Redcloud's profile


32 posts in 2336 days

12-31-2011 10:08 PM

Topic tags/keywords: tablesaw

My first post here and subject says it all. I’m wanting to buy a rip fence for the Rigid 2424 1 table saw. Anyone have a cratered saw they would like to part out?
Thanks in advance!

4 replies so far

View jaydubya's profile


183 posts in 2810 days

#1 posted 12-31-2011 10:48 PM

I have the stock fence for my craftsman 21833 Id sell. Might have to drill a few holes but it should work on any saw. I dont know if its better or worse than the ridgid fence

View Redcloud's profile


32 posts in 2336 days

#2 posted 01-01-2012 05:43 AM

hello Jaydubya, Thank you very much for the response and the offer! I don’t know a bunch about installing a new/different fence system but I’m willing to give it a try. I inherited this saw from an elderly lady who lost her husband several years ago. It did not have a fence when I acquired it nor could she find one anywhere in their garage. So…. any fence would be better than none. The saw runs great was a little rusty and dirty but has cleaned up real nice. It is useless without a fence. I’m assuming you will sell the front and back rails along with the stock fence from your Craftsman 21833? What are you asking for the setup? Of course I would pay, in advance, all shipping costs if you are willing to pack it up and send to the Texas coast? Please let me know when you have time.
Thanks again for the nice offer.

View wookie's profile


154 posts in 3082 days

#3 posted 01-01-2012 10:48 PM


I purchased a Sawstop Premium fence for my Craftsman TS. Paid $180 for the complete system. Had to drill a a couple holes and turn out it wasn’t too scary to do. You might consider the delta T-2 for about $150.

-- Wookie=Wood Rookie

View toolie's profile


2121 posts in 2626 days

#4 posted 01-11-2012 11:22 PM

+1 on the delta t2. i have one on a 10” craftsman CI TS, which is the same saw as the 2424, only built by emerson electric for sears instead of ridgid. i even have detailed installation instructions for the t2 on c-man and, by extension, ridgid, TSs. it is a really good fence that is rock solid and dead on when installed properly. tools-plus has it for under $150:

-- there's a solution to every just have to be willing to find it.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics