router extension on craftsman saw w/ delta t2 fence

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by joshtank posted 10-18-2011 06:07 PM 4631 views 0 times favorited 2 replies Add to Favorites Watch
View joshtank's profile


224 posts in 2395 days

10-18-2011 06:07 PM

Topic tags/keywords: router table table saw fence

since i start the cut from the side of the fence that doesn’t tighten down, the fence sometimes drifts a little bit. anyone else with the same problem or ideas for a solution?

- one obvious solution is to position the fence on the other side of the router table. no biggie, more reaching for me though..

- another, rather inelegant solution, is to use a clamp to tighten down the far end of the fence once it’s set in place.

i was all ready to move ahead with making a router set up i attach to the table saw fence, but then this problem popped up.

-- Josh - Jacksonville, FL -

2 replies so far

View knotscott's profile


7146 posts in 2797 days

#1 posted 10-18-2011 07:38 PM

A separate fence is one solution. Something like this:

-- Happiness is like wetting your pants...everyone can see it, but only you can feel the warmth....

View joshtank's profile


224 posts in 2395 days

#2 posted 10-19-2011 06:33 PM

i thought about the separate fence.. maybe eventually..

so far a c clamp is keeping it simple!

-- Josh - Jacksonville, FL -

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics