LumberJocks Woodworking Forum banner

Virginia Lumberjocks - tools for sale

2K views 0 replies 1 participant last post by  grumpyoldman 
#1 · (Edited by Moderator)
I live in Florida now and have no place for these. MY son used all of them, except the lathe, to build new kitchen cabinets from oak and poplar trees, felled and milled on his property. He had no problems working with rough cut lumber using these machines. All of these tools are near Richmond, VA, stored at my oldest son's house. I do have pictures, but haven't figured out how to post them. If you want photos, PM your email and I'll happily send them to you. My son cannot do shipping. If you want something shipped, you must make arrangements to have the item picked up, crated, and shipped. Otherwise, these must be picked up just about 15 miles NW of Richmond, VA (little burg of Montpelier, VA). I think I have priced these fairly, some maybe too low. Offers will be considered. Contact me at sfox29@tampabay.rr.com
Steve

Radial Arm Saw - Craftsman 3HP 10" contractor series. Shown sitting on a bench, but does include a stand. Stand can be seen in the photo of the lathe (which of course you can't see unless you PM for the pictures). Good working saw. No known apologies.
$125.00

Jointer - Ridgid Model JPO 6000. Probably needs the blades sharpened. Has some very minor surface rust on the top.
$125.00

Planer - Ryobi AP -12 12 15/16". My son said he replaced the blades in this not long ago. No known apologies. This a good older lunchbox planer.
$75.00

Table Router/Shaper- Delta Shopmaster (couldn't find any model #'s) This is a benchtop type machine mounted in some repurposed kitchen cabinets. IIRC this about 1 1/2 - 3hp and uses both 1/4 and 1/2 bits. Porter Cable collet inserts and collet nuts fit. There shoud be both with it, but I'm not sure if my son knows where they are. This is a nice little router. I have cut raised panel doors with this and my son did an enitre kitchen with it. Cabinets are available at additional cost.
$100.00

Lathe - Ridgid Model 70055. Runs good. Has some minor surface rust on the ways. No tools included. What you see is wht you get.
$125.00
 
See less See more
You have insufficient privileges to reply here.
Top