Jointech saw train system on new unisaw

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by bdoane3941 posted 06-13-2011 10:28 PM 3188 views 0 times favorited 1 reply Add to Favorites Watch
View bdoane3941's profile


1 post in 2927 days

06-13-2011 10:28 PM

I have a jointech saw train system (rails and fence system) on a contractor saw that measures 27” front to back. I would like to use the system on a new unisaw that is 31” deep. If I slide the parts out on the fence and sliding bridge to accommodate the deeper table, they will be out of the track and not able to secure them.

Has anyone been able to mount the jointech system on that TS? The Jointech website says that it will fit a 36” TS, I don’t see how.

I have already contacted customer reply.

1 reply so far

View Bertha's profile


13551 posts in 2929 days

#1 posted 06-13-2011 10:30 PM

I’m sure you can MAKE it fit;) I had to tap and thread my JET rails to install a router extension. It was a little nervewracking, but not terribly difficult. Good luck!

-- My dad and I built a 65 chev pick up.I killed trannys in that thing for some reason-Hog

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics