Ineed help

The horizontal one, just tilt you miter gage 10 degrees. The vertical one I would cut the normal way, with the blade set to the shallowest cut, and chisel out the angle. This is assuming that you’re using a table saw to cut your box joints.

-- Tim -- http://tmuli.com

thank you I can see it now. what about a router table

-- Do it right the first time. Becuase fixing it is a wast of time.

If you’re using a fence to guide the piece over the bit, should be the same.

-- Tim -- http://tmuli.com

try setting up as if you are going to cut a featherboard, adjust angle accordingly.

-- Pretzel L8agn