LumberJocks

planer issue

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by mike123789 posted 05-16-2018 02:08 PM 472 views 0 times favorited 7 replies Add to Favorites Watch
View mike123789's profile

mike123789

14 posts in 633 days


05-16-2018 02:08 PM

I have the Rigid 13 inch planer and I like making end-grain cutting boards. My problem is, after milling is done and all the boards are beautiful and done with the first glue up, I plane again to flatten from inconsistency in wood height from clamping and after I make my cross cuts I notice my boards have gaps between because the planer left “birdbath” cups and divots throughout my board. Is this a common problem?


7 replies so far

View TechTeacher04's profile

TechTeacher04

392 posts in 1704 days


#1 posted 05-16-2018 02:14 PM

Do you have any pictures? I am uncertain which side the cupping it on.

View mike123789's profile

mike123789

14 posts in 633 days


#2 posted 05-16-2018 02:48 PM

“cupping” may not be the best word as it is easily associated with board warp. basically when i cross cut and go to fit the boards together there are some pretty extreme gaps especially in the center. but its not consistent through the board. I have no pictures at present

View John Smith's profile

John Smith

1432 posts in 335 days


#3 posted 05-16-2018 03:06 PM

Mike – are you actually running a finished glued up end grain board through your planer ?

.

-- I started out with nothing in life ~ and still have most of it left.

View pintodeluxe's profile

pintodeluxe

5783 posts in 2986 days


#4 posted 05-16-2018 03:11 PM

If you are talking about scalloping or many shallow troughs left behind on the workpiece, then I think it is just a result of trying to plane end grain with straight knives. The stars have to align for that to go right. Some people get away with it, but only under certain conditions.
- brand new sharp knives
-or better yet, helical head
-waxed planer be
-extremely light cuts (remove next to nothing per pass)

I think a drum sander or ROS is a better tool for the job.

-- Willie, Washington "If You Choose Not To Decide, You Still Have Made a Choice" - Rush

View mike123789's profile

mike123789

14 posts in 633 days


#5 posted 05-16-2018 03:40 PM



Mike – are you actually running a finished glued up end grain board through your planer ?

.

- John Smith

No John, this is planing the edge grain before the crosscut glue up. i learned my lesson planing end grain

View diverlloyd's profile

diverlloyd

3172 posts in 2030 days


#6 posted 05-16-2018 04:26 PM

Glue some staringht boards to the sides then put it through the planer.

View bbasiaga's profile

bbasiaga

1240 posts in 2168 days


#7 posted 05-16-2018 04:58 PM

If your plane is leaving a scooped or scalloped surface it might be because one of the blades protrudes a little more than the other. Also I think two knife planers are worse about this than 3 knife models.

Stil,it should be so mistaken jet you can’t see them in the joint. Pics will help.

Brian

-- Part of engineering is to know when to put your calculator down and pick up your tools.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com