LumberJocks

1-1/4" shaper insert tooling

  • Advertise with us

« back to Woodworking Trade & Swap forum

Forum topic by pwk5017 posted 05-11-2018 09:21 PM 339 views 0 times favorited 5 replies Add to Favorites Watch
View pwk5017's profile

pwk5017

55 posts in 1446 days


05-11-2018 09:21 PM

Purchased a lot of steel shaper cutterheads, and while i am keeping about half of them, i am selling the other half along with my set of freud cope/stick/panel sets. Id like to get $500 shipped for both the freud sets. These retail for $850+, and are barely used. Comes with two new groovers, because i misplaced the other two.

The rest of the steel tooling is almost too much to list. Message me if you are interested in USA steel body insert tooling, and i can tell you what i have. Manufacturers are still in business and still offer replacement inserts/knives for everything i have.



5 replies so far

View TungOil's profile

TungOil

1006 posts in 615 days


#1 posted 05-13-2018 04:21 PM

Are they all 1-1/4”? A few look like a smaller bore. I’d be interested in any 3/4” bore cutters if there are any in the mix.

-- The optimist says "the glass is half full". The pessimist says "the glass is half empty". The engineer says "the glass is twice as big as it needs to be"

View pwk5017's profile

pwk5017

55 posts in 1446 days


#2 posted 05-13-2018 04:24 PM

Freud is 1-1/4”. Has a bushing to take it to 3/4”.

The steel tooling is mostly 1-1/4” bore. Some are 1.5”. For about $6, you can buy a bushing to take 1-1/4” down to 3/4” to fit your spindle.

View AlaskaGuy's profile

AlaskaGuy

4371 posts in 2429 days


#3 posted 05-13-2018 04:41 PM



Freud is 1-1/4”. Has a bushing to take it to 3/4”.

The steel tooling is mostly 1-1/4” bore. Some are 1.5”. For about $6, you can buy a bushing to take 1-1/4” down to 3/4” to fit your spindle.

- pwk5017

Exactly, I run 1 1/4 on 3/4 all the time using bushing.

-- Alaskan's for Global warming!

View TungOil's profile

TungOil

1006 posts in 615 days


#4 posted 05-13-2018 04:45 PM

The diameter of 1-1/4” tooling is usually too large for my guard.

-- The optimist says "the glass is half full". The pessimist says "the glass is half empty". The engineer says "the glass is twice as big as it needs to be"

View pwk5017's profile

pwk5017

55 posts in 1446 days


#5 posted 05-13-2018 04:57 PM

I’d have to go measure them individually, but yes, diameter is in the 5” range.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com