LumberJocks

Drawer Lock Bit

  • Advertise with us

« back to Woodworking Skill Share forum

Forum topic by cajunworkshop posted 03-08-2018 03:07 PM 282 views 0 times favorited 2 replies Add to Favorites Watch
View cajunworkshop's profile

cajunworkshop

64 posts in 1111 days


03-08-2018 03:07 PM

Received my Frued 99-240 Draw Lock Bit. Been mostly using pocket hole joinery on thedrawers I have been building Going to take this out to my shop and play around with it in the next couple of days( 29 degrees here this morning just a big buddy heater in my shop).

Before I get started anyone suggest a starting point on height of the bit and how much it protrude from my router table fence opening? I will be using plywood all 4 sides 1/2” or some times 3/4”

Any comments on your success or failure using a drawer lock bit?

Thanks

-- Cajun Workshop Greenville, SC


2 replies so far

View rwe2156's profile

rwe2156

3069 posts in 1596 days


#1 posted 03-08-2018 04:39 PM

About 1/2 way thru front as pictured. Trial and error but once you get it figured out, cut your sides a bit wider to you can trim off the blow out or use a backer board.

I don’t use mine anymore with plywood the tear out is an issue I don’t want to deal with.

I’ve found scribing a line cross grain prior to cut will just about eliminate it.

Keep a set up block for reference.

-- Everything is a prototype thats why its one of a kind!!

View AlaskaGuy's profile

AlaskaGuy

4353 posts in 2424 days


#2 posted 03-08-2018 04:42 PM

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com