LumberJocks

Thank you Matt

  • Advertise with us

« back to Woodworking Skill Share forum

Forum topic by sandhill posted 04-17-2011 10:37 PM 556 views 0 times favorited 0 replies Add to Favorites Watch
View sandhill's profile

sandhill

2128 posts in 2678 days


04-17-2011 10:37 PM

Topic tags/keywords: resource tip veneering

I was watching the series over at Matt’s Basement Work shop about his Buffet he made and showed a tip for repairing veneer so I thought I would try the procedure out for doing inlay. Basically what I did was use my 1/8” spiral cutter and ran a groove the length you see on the board below just a bit shallower then a piece of edge banding, the stuff that comes with glue for iron on. I then put some glue into the groove then laid the edge banding over the groove then wax paper over that, I put a piece of dense foam over the wax paper and clamped it down with a caul then when it was dry I hit it with a card scraper “not a very good one”. I think this can be used for the project I am starting which is an arts & crafts living room set (2 end tables, coffee table and sofa table) and would like to put some accents on them to enhance the design a bit.


0 replies so far

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase