LumberJocks

Delta unisaw

  • Advertise with us

« back to Woodworking Trade & Swap forum

Forum topic by FancyShoes posted 02-06-2018 07:40 PM 386 views 0 times favorited 3 replies Add to Favorites Watch
View FancyShoes's profile

FancyShoes

550 posts in 1358 days


02-06-2018 07:40 PM

Delta 10” unisaw right tilt 5hp 3ph

Runs great, smooth movment throughout tilt and height adjustment. Includes biesmeyer fence 28” fence. $1000

Static phase convertor available to run it for $160 additional.

I will have to post pictures later. Located in Indianapolis, In


3 replies so far

View LesB's profile

LesB

1722 posts in 3437 days


#1 posted 02-06-2018 10:06 PM

Sounds good except for the right tilt blade. I mistakenly and out of ignorance got a Unisaw with the right tilt. It cuts great but for a lot of mitered cuts I have to move the fence to the left side of the table, usually for safety reasons.
Given a choice I would replace it with a left tilt. Mine is a 3hp single phase and has plenty of power. I don’t know much about 3 phase but it sounds like just another technical problem I wouldn’t want. Was the saw use commercially? That could mean a lot of wear on bearings, etc.

-- Les B, Oregon

View Nubsnstubs's profile

Nubsnstubs

1286 posts in 1724 days


#2 posted 02-06-2018 11:34 PM

Right tilt, left tilt. It’s all subjective. If you want the saw, buy it. A 220 volt 3-5 hp motor would cost about the same as a VFD, so change out the motor to 220. You do not need to get the exact same mounting as I made mounts for 56 base that hangs in the Delta motor mount. Been using it since ‘92. Had to make another when I went to 5hp. I’ll post pictures if you ask. ............. Jerry (in Tucson)

-- Jerry (in Tucson) www.woodturnerstools.com

View TheFridge's profile

TheFridge

9444 posts in 1480 days


#3 posted 02-07-2018 12:51 AM

Have 2. Has never been a problem.

-- Shooting down the walls of heartache. Bang bang. I am. The warrior.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com