Grizzly G1022Z Contractor Saw

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by madams posted 03-12-2011 05:42 AM 1336 views 0 times favorited 1 reply Add to Favorites Watch
View madams's profile


1 post in 2598 days

03-12-2011 05:42 AM

As this is my first post, I would like to thank everyone for sending welcome emails. Very nice.

Ok, I just purchased the above saw off CL and is a good upgrade from my direct drive Craftsman. The saw itself is in fantastic condition, no rust or problems with the top. But, there was sawdust caked on everywhere. So, after tearing the saw down and removing the trunnion assembly, a thorough cleaning, I’m putting the saw back together. With the saw upside down, I’ve found that there is some slight play side to side on the trunnion assembly, right where the worm gear is connected to the front trunnion that changes the angle of the blade. There is no play front to back.

So, is this slight movement normal for a contractor saw? My OCD is keeping me from using this saw until I can solve this problem. Any insight will be greatly appreciated.

1 reply so far

View cabs4less's profile


235 posts in 2725 days

#1 posted 03-12-2011 06:56 AM

the rod attached to the handle and to the worm is lateraly adj justable most of the time there is two screws on the outside of the saw behind the angle crank loosen them and push the handle down to take the play out and tighten the screws back

-- As Best I Can

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics