Delta Jointer 37-070

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by roycebryan posted 08-20-2010 04:07 PM 5743 views 0 times favorited 1 reply Add to Favorites Watch
View roycebryan's profile


11 posts in 3081 days

08-20-2010 04:07 PM

Topic tags/keywords: jointer question

I am just starting out in woodworking and have been looking all over e-bay and craigslist trying to get some good deals. I came across a Delta 6” Jointer model:37-070 asking $175 with 2 extra blades. I e-mailed him and he said it is about 5-6 years old. Does anyone have this unit or familiar with it. Would it be something good for a beginner or should I hold out?

Also I have a very small shop not even the size of a 1 car garage so I am limited on floor space so I was thinking of building one of those flip top cabinets I have seen a few people have so I could possibly store something else on the other side of it and flip to which one I would need at the time. Would this be an okay Idea for a Jointer or is it something I should attempt for another piece of machinery.

Thanks everyone loving the site and the support I have been getting from everyone already.

-- Royce, Ohio

1 reply so far

View PurpLev's profile


8548 posts in 3887 days

#1 posted 08-20-2010 04:15 PM

is that the benchtop aluminum table model? if so then:

1. I would not recommend this jointer at all – it’s too light, it’s too flimsy, and not very accurate.
2. if you MUST, than I would not pay over ~$100 for a user one.

-- ㊍ When in doubt - There is no doubt - Go the safer route.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics