How would I glue Rubber to plywood?

  • Advertise with us

« back to Woodworking Skill Share forum

Forum topic by ChrisCarr posted 07-20-2010 05:37 AM 6575 views 0 times favorited 4 replies Add to Favorites Watch
View ChrisCarr's profile


196 posts in 2948 days

07-20-2010 05:37 AM

I am working on something very urgent and need to glue rubber to the end grain of plywood (the edge, where you see the plys.) What adhesive would I use? Also is there a special technique I should use?

4 replies so far

View Ger21's profile


1075 posts in 3180 days

#1 posted 07-20-2010 05:39 AM

depends on the type of rubber, but probably contact cement.

-- Gerry,

View patron's profile


13610 posts in 3390 days

#2 posted 07-20-2010 05:48 AM

go here

they got everything to everything .

-- david - only thru kindness can this world be whole . If we don't succeed we run the risk of failure. Dan Quayle

View David Kirtley's profile

David Kirtley

1286 posts in 3047 days

#3 posted 07-20-2010 07:07 AM

Actually, rubber cement works pretty good for that.

There are two ways to use rubber cement. The paint it on and stick it together makes a less permanent bond. To make the permanent bond, use it much like you do contact cement. Rough up the rubber a bit with sandpaper. The wood should be roughened a bit as well. Put it on both surfaces and let it dry. Then press them together and apply pressure. (Same way you put patches on a bike innertube.) Should hold on well.

-- Woodworking shouldn't cost a fortune:

View SnowyRiver's profile


51457 posts in 3530 days

#4 posted 07-20-2010 04:01 PM

I would think contact cement would work fine.

-- Wayne - Plymouth MN

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics