Grizzly G1022Z Table Saw support a riving knife?

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by LucasWoods posted 11-07-2016 03:30 AM 940 views 0 times favorited 4 replies Add to Favorites Watch
View LucasWoods's profile


445 posts in 1482 days

11-07-2016 03:30 AM

Anyone own or know if a G1022Z can support a riving knife?

-- Colorado Springs, CO - USAF

4 replies so far

View knotscott's profile


8129 posts in 3524 days

#1 posted 11-07-2016 10:20 AM

The BORK might fit that saw.

-- Happiness is like wetting your pants...everyone can see it, but only you can feel the warmth....

View runswithscissors's profile


2846 posts in 2174 days

#2 posted 11-10-2016 02:25 AM

Or, possibly, the ARK from Leeway Workshops (aka Shark Guard).

-- I admit to being an adrenaline junky; fortunately, I'm very easily frightened

View Loren's profile


10477 posts in 3796 days

#3 posted 11-10-2016 07:41 AM

Very few table saws will because usually the blade
height is on a pivot at one end so the blade centerline
moves in an arc as the blade is raised or lowered.

There are some older industrial table saws
and tilt-top table saws where the saw arbor
carriage moves straight up and down and these
are friendliest to conversion for riving knives.

I like having a riving knife but I can get on without
one too.

This sort of thing works well for most cuts… really
how often do you tilt the blade?

View bonesbr549's profile


1576 posts in 3216 days

#4 posted 11-10-2016 03:32 PM

I had a 1023slx and while I did not have a riving knife, I used the microjig splitter and an overarm gaurd. Worked well.

-- Sooner or later Liberals run out of other people's money.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics