LumberJocks

Tablesaw Tuneup

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by BlacksheepWW posted 05-16-2010 03:28 PM 899 views 0 times favorited 2 replies Add to Favorites Watch
View BlacksheepWW's profile

BlacksheepWW

9 posts in 2430 days


05-16-2010 03:28 PM

Yesterday I decided to tune up my table saw, its been a while.

I have the saw blade .002-.003 square to the miter slot and the fence kicked out .010 in the rear.

I was wondering is my saw blade square enough or should it be closer?


2 replies so far

View TomHintz's profile

TomHintz

207 posts in 2864 days


#1 posted 05-16-2010 07:15 PM

I try to get my blade 0.000” to 0.001” but would settle for 0.002” without much complaint. I tail my fence out between 0.002” and 0.005” at the rear. I don’t know for a fact that 0.010” will cause problems but I would think about bringing that one down a little myself.

-- Tom Hintz, www.newwoodworker.com

View Knothead62's profile

Knothead62

2581 posts in 2427 days


#2 posted 05-16-2010 08:01 PM

I read somewhere that a person used a business card as a spacer to determine the distance from the rear of the fence to the blade. Even that might be too much. TomHintz’s reply makes a lot of sense.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com