LumberJocks

Replacing Bandsaw Starter Switch

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by Noab posted 01-25-2010 08:09 PM 11014 views 0 times favorited 1 reply Add to Favorites Watch
View Noab's profile

Noab

8 posts in 2505 days


01-25-2010 08:09 PM

My Laguna Tools LT14 only runs for a few minutes before shutting off. I suspect the Schneider LR2K-0316 magnetic starter switch has gone bad and want to replace it. with a domestic magnetic switch like the Grizzly G4572. The current switch is wired as shown below:

LT14 Wiring

There are 3 wires going in and 5 wires going out: 1 ground, 2 to the outside capacitor, and 2 to the inside of the motor that bypass the switch contactor. Can I replace this with a Grizzly G4572? Grizzley shows this wiring:

Grizzly Switch

Here there are 3 wires in and three wires out. Do I map the Schneider wiring to the Grizzly switch or do I somehow follow the Grizzly wiring as shown?

-RogerT


1 reply so far

View lew's profile

lew

11336 posts in 3216 days


#1 posted 01-25-2010 09:57 PM

When I replace my table saw switch (single phase 1.5hp 120v) with the Grizzly switch, I followed the Grizzly wiring diagram. Worked perfectly.

Lew

-- Lew- Time traveler. Purveyor of the Universe's finest custom rolling pins.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com