|Forum topic by Viking||posted 01-02-2010 01:42 AM||2029 views||0 times favorited||2 replies|
01-02-2010 01:42 AM
Just finished assembly of my new Ridgid DP-1550 Drill Press. Assembly went very well and other than needing a slight adjustment to the motor height to align the motor pully to the quill pulley everything else was in spec. and run out on the quill is almost nill. I promise to do a complete review and pics in a few days after I build a mobile base (looking for some ideas) and drill press table for it.
Question? Do any of you LJ’s have a recommendation of what to use to remove the protectant from the table and other surfaces so I can apply some paste wax? Have same issue on protectant applied to the tables on my new Ridgid JP0610 jointer that was assembled a few days ago.
Thanks in advance for your advice.
Happy New Years to all!
-- Rick Gustafson - Lost Creek Ranch - Colorado County, Texas