|Forum topic by sjbob||posted 11-16-2009 06:07 AM||4351 views||1 time favorited||1 reply|
11-16-2009 06:07 AM
I thought I would post the information I received from Delta in 1997 on how to wire the Delta 34-444 (circa 1990) table saw for either 115 or 220 VAC. I’m doing this because I’m pretty disappointed that this is not a standard set of information in the user manuals, and thought it would be good to have it archived in the internet.
Here is the information, verbatim:
Remove cover from wiring compartment in motor endbell. Inside the compartment you will find different color wires hat terminate in quick connect terminals. These wires are connected to 1/4” male spade terminals which are secured to a white plastic terminal board. The 1/4” male spade terminals are marked with the numbers 1,2,4,5,6.
For 115 volts:
To reconnect for 230 volts:
Replace the cover on the wiring compartment. Cut the 115 volt attachment plug off the power supply cord and install a 230 volt attachment plug.
-- Every project is a learning experience.