|Forum topic by trophyjoe||posted 07-30-2015 07:39 PM||784 views||0 times favorited||2 replies|
07-30-2015 07:39 PM
This turned out better than I expected. It’s just a piece of 1/8” aluminum angle with some tapped holes to hold the blades so that the two can be honed at the same time. Not sure if there is anything new about it, but here it is, for what it’s worth.
The angle just needs some sort of cradle. I used the slot on my table saw. (I was in a hurry) I used four grits of diamond, but the last was 1000 grit and I’ve heard that’s overkill. I used it cause it was there. The screws are #6×40 brass
There is more about this on my” Wordpress page”: https://trophyjoe.wordpress.com/.
-- Perfection is achieved, not when there is nothing more to add, but when there is nothing left to take away. Antoine de Saint-Exupery