Asking Price For Ridgid R4512

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by SonOfMI posted 07-21-2015 06:44 PM 824 views 0 times favorited 4 replies Add to Favorites Watch
View SonOfMI's profile


15 posts in 1065 days

07-21-2015 06:44 PM

I own a Ridgid R4512 table saw that I bought new from Home Depot a couple of years ago. It worked ok for the time I had it, but I spent a lot of time of setting up for cuts due to the documented alignment issues. At the beginning of May I finally took it to an authorized Ridgid repair center near me to get it looked at. They called me back yesterday saying they received and installed a new trunnion from Ridgid that they state fixed the problem of the blade shifting when raised or lowered. I will not have time to pick the saw up from the repair center until this weekend to test it. In the meantime I upgraded to a Grizzly G0690 for multiple reasons. I plan on picking up the Ridgid and trying to sell it.

I will be including 4 inserts I cut out of UHMW for the saw, the original miter gauge (which needs repair as the rubber/plastic knob on the tightening screw came off – not covered under Ridgid’s LSA), the saw, its stand, original fence, unused blade that came with it, owner’s manual, and of course the tools to adjust, assemble and change blades. The saw is in good condition and supposedly should be working better than when it was new with this updated trunnion. What would be a good price to ask for it?

4 replies so far

View knotscott's profile


8056 posts in 3400 days

#1 posted 07-21-2015 11:09 PM

The general rule of thumb is ~ 50% of the cost of new, with some wiggle room for initial quality, condition, location, extras, etc….keep in mind that most extras don’t add much value, and this is essentially an entry level stationary saw. I’d think somewhere in the range of ~ $300 would be a fair asking price.

-- Happiness is like wetting your pants...everyone can see it, but only you can feel the warmth....

View Rob's profile


316 posts in 3012 days

#2 posted 07-21-2015 11:39 PM

knotscott is correct. 50% of new is pretty much the norm. Probably a ahrd pill to swallow with it only being a couple of years old. If you have room in your shop, I’d put it on a mobile base and make it a dedicated saw for crosscuts or dado’s or some other task.

View SonOfMI's profile


15 posts in 1065 days

#3 posted 07-22-2015 05:29 AM

Thanks for the info. It’s in the ballpark of what I was thinking. I’ll be selling it with whatever came with it new. I didn’t think the throat inserts would add much value but I already cut them for this saw. They don’t fit my grizzly so I might as well throw them in. I didn’t pay full price for the saw since Home Depot accepted a Harbor Freight 20% off coupon when I bought it. It was $499.99 when I bought it. Minus the 20% coupon I was out the door for under $425. I’ve gotten more than $200 out of it so I’ll probably let it go fairly cheap.

View jonah's profile


1727 posts in 3324 days

#4 posted 07-22-2015 12:07 PM

I agree with what Scott and Rob said. Start at $300-$325 and be prepared to take ~$250-$275 if someone talks you down to there.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics