LumberJocks

Making drawer pulls

  • Advertise with us

« back to Designing Woodworking Projects forum

Forum topic by pat44 posted 09-19-2009 01:48 AM 1930 views 0 times favorited 2 replies Add to Favorites Watch
View pat44's profile

pat44

19 posts in 2856 days


09-19-2009 01:48 AM

I’m interested in making drawer pulls for a project and was looking for ideas. I would appreciate any suggestions. Thanks


2 replies so far

View okwoodshop's profile

okwoodshop

448 posts in 2639 days


#1 posted 09-19-2009 04:01 AM

I have made simple pulls by cutting a long piece of stock out of 3/4 and 1 1/2 wide. run one side on a cove bit for the finger pull side. The opposite corner can be a round over or other profile, cut them to the length you want at 30 to 45 degrees. glue and screw them on. Don’t glue if you think you might change them someday. Also you can use different wood to make a contrasting color

View scrappy's profile

scrappy

3506 posts in 2895 days


#2 posted 09-19-2009 08:17 AM

Here is an idea for a simple pull on my daughters project ” man box for her husband” The lid handle is just square but the drawer pull is undercut with a cove bit. Inset into the drawer front and glued in place.

-- Scrap Wood's the best...the projects are smaller, and so is the mess!

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com