LumberJocks

Paul Bucalo's Forum Topics

  • Advertise with us
View Paul Bucalo's:homeworkshopprojects (12)blog (95)reviews (0)forum topics (5)buddies (14)favorites (15)activity logWatch
08-27-2015 04:56 PM

Table Saw: Sizing the Correct Table Top Height - 12 replies

I recently purchased from a local widow my first hybrid table saw, a 2009 Hitachi C10FL. It had been sitting idle for a few years, so there was much cleaning and adjusting to be done. I’m at the tail end of all that, and in running test cuts it occurred to me how ‘tall’ this saw is on its factory stand, approximately 36 inches....

12-08-2014 01:12 PM

ProCom Vent-Free Dual Fuel Infrared Radiant Wall Heater Safe For Dusty Environment? - 5 replies

I found this discussed in a YT video by a woodworking peer who recently installed this in his workshop. The cost is very reasonable and since I have a natural gas furnace, and an unused connection in the dungeon, this seems like a good choice for me. What I am concerned about is combustion from wood dust in the air, plus the fact that I would ha...

11-07-2014 03:11 PM

Comments on mounting dust extraction port on back of table saw body - 0 replies

While I wait for a 2-1/2” dust extraction port to come in from Rockler, I am mulling over whether it is a good idea to mount it right off the plastic body of my Delta 36-510 Table Saw instead of cutting through the melamine and chipboard top for a traditional under-saw extraction. Here is a blog entry with the saw mounted to the multi-purp...

10-11-2014 04:28 PM

Broken rear tail pieces on table saw insert plate - 8 replies

I have never owned a tool that worked so hard against me. Just when I thought I had this thing licked, it twacked me again with a forehead smack. So the Skilsaw 3410-02 saga continues. You now have permission to groan. Today is the first day of a long weekend, one in which I planned on getting quite a few projects done on and around the house...

10-03-2014 04:18 PM

Gripper push block system on textured surfaces - 38 replies

I have a Skilsaw 3410-02 with a heavily textured cast-aluminum top. Does anyone have experience with using a Gripper push block on this kind of surface? I am thinking it will not glide well, possibly be binding. I don’t want to invest in such an expensive system if it won’t work on this kind of table saw top.


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com