LumberJocks

stevo_wis's Blog

  • Advertise with us
This blog is written by stevo_wis | 11 entries so far

Latest Entry

Barnsley Reproduction Build #11: Diagonal Tenons Almost There

12-24-2014 03:57 AM by stevo_wis | 3 comments »

The diagnonal tenons can be shaped on the table saw almost identically to the way a 90 degree tenon would be made. I cut the inside cheek cut very carefully and then quickly nibble out to the tenon’s tip.Because the shoulder will hide where the tenon actually enters the mortise, i can cut the tenons to width with the bandsaw. The tenons can slightly narrower than the mortises as they will match up to end grain which gives little glue strength, and they are covered in any case. after cutting, I trimmed the entire shoulder with a chisel to get a nice line that does show. One joint at a time I tried each tenon into it’s mortise. They had a way to go, so it was time t...

Read this entry »

Older Entries


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase