LumberJocks

Mark's Blog

  • Advertise with us
This blog is written by Mark | 14 entries so far

Latest Entry

Dining Table Build #4: Upper and Lower Sretchers

09-11-2014 09:57 PM by Mark | 2 comments »

I built the top stretchers using 2 5/8 X 4/4 stock I shaved down to 7/8. Then I cut a 3 ¾ tenon on each end. And a quick clean up. The lower stretcher is 7” x 7/8 with a 3 ¾ tenon on each side. I took the end assemblies apart to cut the mortises in the lower splats and the upper part of the legs.After drilling a series of holes to remove the bulk of the waist I clamped a block to the work piece to ensure my chisel cuts were straight. And the same for the upper legs. I used the same procedure with the stretchers, only this time I used a block cut to 7°. This is the angle for the wedges. I cut the upper and lower wedges form scrap Walnut. After laying out the 7° ...

Read this entry »

Older Entries

View all 14 entries »


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase