Knitting box #8: Slides, Knobs, Top Separation
I set up the router table to make the slots for the slide rails. I just used a 1/2” straight bit to make the groove and I sized my rails to fit later. So here I used a chisel to square up the fronts of the grooves that I just routed. This is not really necessary it will just make it easier to adjust the drawers forward or backward if they don’t line up just right, Which they didn’t in the end. I had to remove just a bit more towards the front on one side so that they came in line after sliding the drawer in. Also, it doesn’t scream ” Hey I cut this with a router and was too lazy to clean it up”. Here I cut the rails that will be attached t...
