LumberJocks

RAS Cabinet #3: Getting started with the case

  • Advertise with us
Blog entry by sIKE posted 08-25-2008 03:59 AM 966 reads 0 times favorited 2 comments Add to Favorites Watch
« Part 2: The Cabinet Design and Sketchup Part 3 of RAS Cabinet series Part 4: The Case work is done »

As previously posted, I had worked out the details to my RAS cabinet using Sketchup. I started working on the cabinet this weekend and the reality of my previous work objected to the finest of my plans. With the miter bench not being sqaure, I have going to have to adjust my plans for the RAS cabinet.

I am going to have to take an inch off of the width of the cabinet and the torsion box. This is so I can make the cabinet square. I will then have to set the cabinet into its place and scibe filler strips in on each side to make up the difference. Oh well! Hopfully I can get this taken care of tommorow.

-- //FC - Round Rock, TX - "Experience is what you get just after you need it"



2 comments so far

View Lee A. Jesberger's profile

Lee A. Jesberger

6819 posts in 3444 days


#1 posted 08-25-2008 03:29 PM

Hi sIKE;

That’s good news! My plans never work out either. I thought it was just me.lol

Have fun;

Lee

-- by Lee A. Jesberger http://www.prowoodworkingtips.com http://www.ezee-feed.com

View sIKE's profile

sIKE

1271 posts in 3218 days


#2 posted 08-25-2008 05:50 PM

Thanks Lee. I am working hard to make this cabinet square!

-- //FC - Round Rock, TX - "Experience is what you get just after you need it"

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com