LumberJocks

Workshop #13: Table Saw Workcenter - wobbly legs

  • Advertise with us
Blog entry by rweitz posted 1296 days ago 1249 reads 0 times favorited 0 comments Add to Favorites Watch
« Part 12: Table Saw Workcenter - 2 Part 13 of Workshop series Part 14: Table Saw Workcenter - outfeed basis »

I used some of the cutoff angle iron from the frame and made some braces for the legs – worked wonderfully and now the saw rolls well in all directions with no sag or bending. The legs on the frame were already braced in one direction so I just needed to add one set of braces. If you use a bed frame look at the bracing before you get the saw on top, it would have been much easier to brace these when I had more room to work.

Notice the bent leg in the upper right corner of the pic above to see what I mean.
the pic below shows the bracing.

-- You cannot build a reputation on what you are going to do. - Henry Ford



0 comments so far

Have your say...

You must be signed in to post the comments.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com

Latest Projects | Latest Blog Entries | Latest Forum Topics

GardenTenders.com :: gardening showcase