|View Rob Vicelli's:||home||workshop||projects (6)||blog (1)||reviews (0)||forum topics (4)||buddies (0)||favorites (20)||activity log|
|01-14-2014 02:17 AM||
Need some joinery ideas for this window shade - 2 replies
HI, Maybe a fellow LJ has some other ideas or has built something like this before and can share. I am building a Sliding window shade, it has been requested to be made from Walnut. I have decided on the slide hardware. The layout will be like the attached picture, the outer frame will be doweled/glued as will the shade frame. I just cannot ...
|06-13-2012 02:15 AM||
When making a table top should I........ - 7 replies
I am in need of a little advice. I am building a kitchen table 38×60 with 1 12” leaf. The top is hard maple with a finished thickness of 1 1/8” and the boards run the length of the table and each board will be about 5 7/16 wide. So when getting ready for glue up should I glue them up at full length cut the pieces using a circula...
|01-10-2012 11:19 PM||
Add a side crank to my old router lift - 3 replies
So as I progress in this winter’s project of fixing up the garage shop and dialing in my tools, I find that I really want to purchase a woodpeckers Sidewinder router lift. It seems that my adjustment hole is always covered or the crank hits my digital gauge I use for setting the height of the bits. Since the router lift cut out in my table...
|01-22-2011 05:53 AM||
depth of dado - 2 replies
Hi, i am building some lower cabinets for my kitchen and previously for lowers I followed sommerfeld’s t&G method. For these cabinets I would like to use levelers so I will need to change my constuction methods as the T&G method will not allow the lower shelf/bottom to support the cabinet weight so I plan to dado the lower shelf in...