LumberJocks

robscastle's Blog

  • Advertise with us
This blog is written by robscastle | 218 entries so far

Latest Entry

Tool Tip #25: Making Architrave Corner Blocks

06-03-2016 05:29 AM by robscastle | 7 comments »

I needed to see if I could make some door trim Corner Blocks for a houseThe job has been on the back burner for some time as I couldnt figure out how to do it. The router bit I have is called a Dragon Ball and its 2” or 50 mm diameter not some thing you could put in a hand held router.I initally tried my drill press but it was an outright all round fail, not enough RPM, not enough power, so that idea was scrapped almost as quickly as it started. I then decided to mount it in my shaper/moulder and try again. As this was almost the opposite setup from before I didnt hold too much hope on it. Well it actually worked albeit I could not see what I was doingI checked the Shaper m...

Read this entry »

Older Entries

View all 218 entries »


DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com